 |
Add an 8” length of metallic for a hanger. Thread needle and slip
under one stitch on the back of the wing’s curve. Hold both ends of the
metallic, allowing the angel to dangle to see if you have chosen a spot
where she will balance. If not, pull that stitch out and try another spot
until she flies smoothly. Tie ends together. Enjoy!
|
| This chart may not be re-sold,
nor may it be used as any part of a kit that is to be sold. |
|
Copyright 2003 by
Jean R. Farish. All rights reserved. No portion of this page may be reproduced
by any means without expressed written consent of Jean Farish, unless
explicit permission is granted within the text of the page. Please read Fair Use
clause. To obtain written permission, please address all correspondence to Jean
Farish, 2425 Queen Street #9, Winston-Salem, NC 27103.
|
